First, the preparation stage
Equipment inspection:
Before use, open the packing box (such as a new machine), check whether the various parts of the hair removal machine are intact, and whether fasteners such as screws are loose. If it is loose, reinforce it in time.
Check whether power cables and ground cables are properly connected to ensure electrical safety.
Check whether the machine roller or turntable rotates normally and there is no stuck phenomenon.
Environmental preparation:
Make sure the hair remover is placed in a smooth, well-ventilated area.
Install the gate dao switch or cable switch on the panel wall next to the machine to control the power supply.
Check whether the water supply is sufficient and whether the water supply from the switch faucet is normal.
2. Poultry treatment
Slaughter and cleaning:
When slaughtering poultry, minimize the incision to reduce damage during depilation.
After slaughter, put the poultry into about 30 degrees of warm water to soak, and add an appropriate amount of salt in the water to avoid skin damage when plucked.
Hot water wash:
Place the soaked poultry in hot water at 65-75 degrees (it may vary depending on the equipment) and stir gently with a wooden stick to ensure that the whole body is evenly heated. This step is a key step before hair removal and directly affects the effect of hair removal.
Three, hair removal operation
Release poultry:
Put the scalded poultry in batches on the flat plate of the depilator, and swing the flat plate to send it into the machine. One to five birds can be placed at a time, depending on the equipment model and poultry size.
Start the machine:
Turn on the dao switch or power switch and the machine will run automatically. At this time, hot water can be added to the poultry (if necessary), as the machine runs, feathers and dirt will be discharged with the water.
Hair removal and rinse:
After about ten seconds, turn on the faucet for flushing, and the machine continues to run for 10-30 seconds to ensure that the feathers and dirt are washed away.
After the completion of hair removal, step on the foot pedal (if any), the molted poultry will be sent out of the machine with inertia.